|
morso manual
hi everyone my name is lawrence,Ive just purchased a crap load of framing gear and im hoping to get to start doing some framing soon.
in all the gear is a morso mitre cutter and I was wondering if anyone knew where i could download a users manual?
any help and advice greatly apreciated
these are the things ive got so far ... tell me what u think good or bad Im wanting to eventually start a framing biz/hobby part time
Morso Mitre cutter with left hand and right hand support bars plus 1 set of spare blades ( worn but useable)
Casesse CS 810 Pneumatic underpinner
C&H 60" Straightline mountcutter
C&H Oval/Circle mountcutter
Fletcher Terry wallmounted glass cutter. (will take glass upto 6'X4')
Guillotine table with foot operated clamp. (Works perfectly, but adjuster knob need new wire loop underneath)
Ademco 60"x40" Vacuum heatseal/mounting press. (This is massive, but the most useful piece of kit ever)
2 Senco Pneumatic staple guns for fitting backing into rear of frame
1 Pneumatic Flexitab gun
Bambi air compressor (A bit old now, but works OK)
Airlines & fittings
2 Very solidly built 6'X4' workbenches
Mountboard rack with work surface on top
Enough Senco staples to last a V long time!
1,000's of Cassese wedges for underpinner
Browser Rack to keep artwork in
Screws, D rings, picture wire, woodstain, some wood paint, very nice moulding corner samples, floor mounted rotating sample display stand, box of fittings for aluminium frames
Ruling pens for mountboard decoration plus various inks
Production stops for Morso (Useful for making multiple frames of the same dimensions)
cheers Law
|
I've moved your post to the Studio Tips/Framing forum as they're more likely to be able give you the answers you need.
Linear Mode
