- This topic has 12 replies, 10 voices, and was last updated 4 years, 7 months ago by
.
Viewing 13 posts - 1 through 13 (of 13 total)
-
Glass Engraving on a wine glass.
Dental technician flex drive drill. Diamond tips and carborundum wheel.
Jim
[ATTACH]868132[/ATTACH]
that looks difficult… well done
Federico Garcia
My Blog
C&C always welcome
"...when someone gives a critique of your work, fear not. It usually means they like or care more of your work than when they just pat your back." - Tiago
This is quite stunning. It must take a light, precise touch to engrave on a glass. Wonderful!
You might be surprised just how tough glass is. I only ever broke one , and that was because I went too near the top. There is usually a ‘stress’ line just below the top, caused when the rim is re heated to make the rolled ‘lip’. There was a ‘ting’ and a perfect ring came away from the top of the glass
Jim
Viewing 13 posts - 1 through 13 (of 13 total)
- You must be logged in to reply to this topic.