Re: temperature controller tutorial
Revisiting a very old thread, but I felt I had to thank Mark again for the inspiration and his effort in this tutorial.
I built one of these a couple years back, and have just completed my second. Now that I have more than one kiln and more than one power requirement, I have created this "hybrid" that will run any of my kilns, up to 45 amps, no matter if 120 or 240 volts!
Built around an Omega CN7500 and with K type TC, and with output receptacles for either type kiln, I can run any kiln I own without a lot of hassle and reprogramming, rather just plug, choose program, and go!
Thanks again Mark, if you're out there!
And Happy Kilning Everyone!