Hi all
I’m trying to print some plates onto 100% cotton.
I had tested with smaller plates onto the same fabric with no problems but the new plates are coming out very faint. They print perfectly onto paper, though, so I am at a loss!
Has anyone got experience of printing hardground on fabric and any word of advice?
This sounds like that there is not enough pressure. With small plate you probably got more pressure since the plate was small, but with larger plate it might not be enough.
When printing to fabric you might also need to experiment with the blanket materials. I could imagine that something like thin silicone or rubber sheet (or anything elastic) could work well with fabrics.