WetCanvas

WetCanvas (http://www.wetcanvas.com/forums/index.php)
-   Scratchboard Art (http://www.wetcanvas.com/forums/forumdisplay.php?f=347)
-   -   Cheap and EASY way to dramatically Frame yer Scratch. (http://www.wetcanvas.com/forums/showthread.php?t=500287)

Tapecat 06-05-2008 11:44 AM

Cheap and EASY way to dramatically Frame yer Scratch.
 
OK folks I do a LOT of very very custom High End Framing but I was looking for a nice and easy way to present my scratch w/o breaking the bank.

The Materials:

Some 1/8th" black foam core board, a $12 Dick Blick DEEP Frame, a $1.98 mat set-up, Double sided tape & foam double sided tape.




My instruction will be for THIS frame holding a 5" x 7" Scratch on Clayboard, make adjustment to suite your own frame and needs.

I cut 4 strips of Foam Board @ 3/4" wide. Cut 2 to 8" & 2 to 9 3/4".

Attach double sided tape to one side of the strips.

Drop in the glass or Plastic(These frames come with plastic)

Attach the foam to the insides of the frame.




CLEAN and set aside.

Next use the double side tape on the Mat and attach it to it backer.



Cut a piece of Foam board to 5" x 3" and apply two pieces of FOAM double sided tape to each side.

Remove the backing and attach the foam to the scratch.



Pull off the remaining backer and attach it to your backer/mat. Take your time here and get it centered correctly or it won't look good and you'll blow the $1.98 mat and a bunch of time fixing the problem. Sorry the flash didn't go off on this but you get the idea. It might actually be better because you can see the extra height this creates a little better.



Make sure your glass is CLEAN and drop in your mat/art combo into the frame.

The frame comes with a hardboard backer with a lip to side into the stock set up. This needs to be removed & can be done quite easily with a ruler and a knife. I have two large cutting boards and I used one of those.

The stock clips should also be removed. grab the tabs with a Needle Nose Pliers and roll to Pliers up and over the attachment point and they pull off easily.



Once that's done drop it on top and using Glazers points you can close this project up.



You can then add a hanging strip that comes with the frame and dust tape the gap.

One REAL bonus is this thing will stand on it's own so showing them off on a table they look real nice.



The art is floating and casts a nice dramatic shadow to lure in the prospective buyer.

Hope you folks can use this little tip, I mean come on framing like this for 15.00 BUCKS! How can ya go wrong!:D

PatrickHedges 06-05-2008 07:07 PM

Re: Cheap and EASY way to dramatically Frame yer Scratch.
 
Thanks for doing all that. I'll add this to the 'helpful tricks and techniques' sticky thread so everyone gets to see it :)

Bertoni 06-05-2008 08:53 PM

Re: Cheap and EASY way to dramatically Frame yer Scratch.
 
Lookin' real good! A great suggestion!!!:thumbsup:

Garbonzo 06-05-2008 09:36 PM

Re: Cheap and EASY way to dramatically Frame yer Scratch.
 
Tapecat, awesome thread, thanks for sharing the info. I really appreciate it, it looks great.

betz 06-06-2008 06:34 PM

Re: Cheap and EASY way to dramatically Frame yer Scratch.
 
omigosh. I've been looking for an idea like this. thanks so much!

SueW16 11-25-2013 12:54 AM

Re: Cheap and EASY way to dramatically Frame yer Scratch.
 
Great idea! I'm thinking of doing a series of small boards and this might be just the way to frame them. It'll make the small pieces look more substantial...plus a LOT easier to frame.
Thanks :)

ggart4u 11-25-2013 07:12 AM

Re: Cheap and EASY way to dramatically Frame yer Scratch.
 
Looks great!

Trilby 11-25-2013 12:50 PM

Re: Cheap and EASY way to dramatically Frame yer Scratch.
 
Floating the board looks great. Thank you.
TJ

Harry Seymour 11-25-2013 04:37 PM

Re: Cheap and EASY way to dramatically Frame yer Scratch.
 
I really like that floating effect.

snoball 11-29-2013 06:23 AM

Re: Cheap and EASY way to dramatically Frame yer Scratch.
 
Excellent idea, especially for small boards!

XQB 11-29-2013 09:50 AM

Re: Cheap and EASY way to dramatically Frame yer Scratch.
 
Excellent! I've been doing a variation of this with "shadowbox" frames for several years. Usually use a black mat board to back it, and occasionally insert a thin ivory or color mat against the glass, lending more to the "floating" illusion. My version isn't quite gallery-quality, but works pretty well for more humble displays (and I've one 4-time client who insists on this method for continuity sake; as I have done his cars and bikes, I've done a small Chevy or Harley emblem in the upper right corner of the top mat).

Blick Art Materials 11-29-2013 02:42 PM

Re: Cheap and EASY way to dramatically Frame yer Scratch.
 
Hi Tapecat! Very nice use of our frames! The directions for creating the floating display were very easy to follow! Thank you for the post!

Audra


All times are GMT -4. The time now is 02:01 PM.


2014 F+W All rights reserved.