View Full Version : Some help please
04-27-2006, 05:24 PM
I want to make a plexiglas box around a piece as a protection device. Have any of you done this before and if so what are the major secrets to make it look just right?
04-27-2006, 05:56 PM
Howard, wish I could help but I can't with this one. I'll bump the post up!:)
04-27-2006, 06:21 PM
Oh, I thought it was your thread I'd been following on building these. If that wasn't you, I'll try to find it.
04-27-2006, 07:29 PM
I may have started a thread earlier and lost track of it. That can happen so easily I fear.
Never hurts to ask again as folks come and go and you never know who is out there lurking about. yes, I see you folks out there...I'm keeping my eye on ya'll.
04-27-2006, 07:56 PM
Ive worked in an acyrlic/plexi factory (long long time ago) one thing i recall was "flaming" the edges with a torch to remove saw marks and make it clear again, like spray paint multipul light passes are better than one intense pass
vBulletin® v3.5.8, Copyright ©2000-2019, Jelsoft Enterprises Ltd.